rejection ratio वाक्य
उदाहरण वाक्य
मोबाइल
- The standard measure of this defect is called the common-mode rejection ratio ( denoted CMRR ).
- The common-mode rejection ratio is defined as:
- I mean, we have enormous rejection ratios.
- The ability of a receiver to reject interfering signals at the image frequency is measured by the image rejection ratio.
- The ability of the receiver to reject this image gives the image rejection ratio ( IMRR ) of the system.
- In the typical 741 op amp, the common-mode rejection ratio is 90 dB, implying an open-loop common-mode voltage gain of about 6.
- Otherwise, an analog component with poor power supply rejection ratio ( PSRR ) will copy fluctuations in the power supply onto its output.
- Every real operational amplifier has a finite power supply rejection ratio ( PSRR ) that reflects how well the op-amp can reject changes in its supply voltage.
- In instrumentation systems, the use of differential inputs with high common mode rejection ratio, to minimise the effects of induced AC signals on the parameter to be measured, is widespread.
- To maximize the common-mode rejection ratio ( CMRR ), differential probes must provide two signal paths that are as nearly identical as possible, matched in overall attenuation, frequency response, and time delay.
- The magnetic immunity of star quad cable is a function of the accuracy of the star-quad geometry, the accuracy of the impedance balancing, and the common-mode rejection ratio of the balanced receiver.
- "' Power mode rejection ratio "'( "'PMRR "') is a term used in electronics and defines how much noise or voltage variations in the power supply will affect the output signal ( s ).
- The common-mode rejection ratio ( CMRR ), usually defined as the ratio between differential-mode gain and common-mode gain, indicates the ability of the amplifier to accurately cancel voltages that are common to both inputs.
- Across all its affiliate banks, the rate of rejection of black mortgage applicants is closer to the rate for whites than the national average for all banks, and the rejection ratio at its Jacksonville bank is half the national average.
- In electronics, "'power supply rejection ratio "'or "'PSRR "'is a term widely used in the electronic amplifier ( especially operational amplifier ) or voltage regulator datasheets; used to describe the amount of noise from a power supply that a particular device can reject.
- ;Common-mode rejection ratio ( CMRR ) : In balanced audio systems, there are equal and opposite signals ( difference-mode ) in inputs, and any interference imposed on both leads will be subtracted, canceling out that interference ( i . e ., the common-mode ).
- These amplifiers are designed to amplify a very small " sense voltage " of 10 to 100 mV, in the presence of very large common-mode voltages of 5 to 30 V . DC precision ( low input offset voltage ) and high common-mode rejection ratio ( CMRR ) are distinguishing characteristics of these amplifiers.
- Most commonly, quantities called " dynamic range " or " signal-to-noise " ( of the camera ) would be specified in 20 log dB, but in related contexts ( e . g . attenuation, gain, intensifier SNR, or rejection ratio ) the term should be interpreted cautiously, as confusion of the two units can result in very large misunderstandings of the value.
rejection ratio sentences in Hindi. What are the example sentences for rejection ratio? rejection ratio English meaning, translation, pronunciation, synonyms and example sentences are provided by Hindlish.com.